Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#1 Installing the new valve page 128
ATTACHMENT #1 - PageThis clearance can readily be checked after the parts are assembledin the engine, by turning the engine over until the valve is free in thelifted position. It should then be free and the actual clearance can bemeasured by locating an indicator on the valve head and noting the reading -then the valve is moved vertically. This clearance can be .0002", providingthe valve turns freely, to not over .004" maximum vertical movement.RECOMMENDED INSTALLATION1. Check valve guides after cleaning out the deposits, and ifbell-mouthed or worn so that the clearance is 50% over theoriginal factory recoomendation, install new guides.2. Re-face cylinder seats and check with indicator.3. Inspect valves and seats to be certain that parts have notbeen nicked in handling.4. Turn the engine until the valve is lifted and check freedomby turning the valve head.SERVICINGThe valve assembly should improve valve life so that, undernormal conditions,they do not need to be checked until the engine is readyfor overhaul. Normally, the greatest wear will occur on the portion of thekey that contacts the valve groove face. If this is excessive, the keysshould be discarded.Before reinstalling, check clearance by assembling retainer, keys,and cap to valve. Hold retainer and press on cap. Rotate valve whilepressing parts together. The valve should turn freely. If binding occurs,it may be due to nicks, dirt, or cap too shallow. To correct for shallowcap, either use new cap or grind valve tip face.If valve is free, check clearance by inserting small piece of shimstock .004" thick between valve tip face and cap. Press parts together. Ifvalve does not bind, clearance is too great and should be reduced by polish-ing the cap open end against a piece of fine emery cloth. Recheck clearanceand rework cap until not more than .004" shim stock is required to bindvalve.128Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
