Chapters
Chapter 7 - Steering Gear
Adjustments page 102
motion during the next1/2turn toward the center position, the tubeshaft bearings do not require adjustment. Proceed as instructed inpars, a and b below. If no adjustment is required, proceed as in-structed in par. b only.a. Steering Tube Shaft Bearing Adjustment. The actualadjustment of the steering tube shaft bearings requires the removalof the steering gear from the tractor.(1) REMOVE STEERING GEAR. Remove the steering wheelwith a puller.To remove the hood, shut off the fuel at the fuel shut-off valve, anddisconnect the fuel line to the carburetor. Remove the four capscrews that secure the hood to the instrument panel. Remove the capscrews that secure the hood to the front axle support. Remove theintake air screen and connection. Lift off the hood.Remove the air cleaner, tool box, battery, battery box, and chokerod.Disconnect the throttle rod at its rear end, the governor compen-sating spring at the housing end, the starter wire at the switch end,and the oil line at the oil gauge.Remove the two bolts that secure the steering gear to the instru-ment panel. Lift the instrument panel assembly off the steering shaft,but do not detach any of the wiring.Remove the four bolts at the base of the steering gear, and lift outthe assembly.(2) ADJUST STEERING TUBE SHAFT BEARINGS. Removethe four cap screws that secure the steering tube to the steering gearhousing. Pull the steering tube upward to remove or install shims asrequired. Shims vary in thickness and only those of the correct thick-ness must be removed or added to complete the adjustment. Forexample, if the spring scale reading was approximately1/4pound,only one of the thinnest shims need be removed. It is better to havethe bearings adjusted tightly rather than loosely, because loose bear-ings permit hammering and produce subsequent failure.Reassemble the steering gear, and check the adjustment as out-lined above.b. Sector Adjustment. If the steering wheel has been removed,it must be installed temporarily to complete the sector adjustment.Turn the steering wheel until the pitman arms are parallel and bothpoint to the rear approximately 15°. Hold the steering wheel in thisposition, and feel for backlash by grasping the left pitman arm. If nobacklash is apparent, no adjustment is required. If backlash is pres-ent, adjust the left sector.§ 121. b.3730-47J102Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
