Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 7 - Steering Gear

Inspection and repair page 104

Ford 8N, 9N, 2N Service Manual, page 104ing. Remove the four cap screws that secure the steering tube to thesteering gear housing. Lift the tube and shaft assembly (fig. 1) fromthe housing.CAUTION: When the steering gear is partially or completelydisassembled, the ball nut assembly must not be permitted toturn so that it reaches the end of the worm on the steeringshaft as this action may damage the ball retainer.Remove the three screws and clamp from the ball nut assembly(fig. 2). Lift the two ball retainers from the assembly and remove theball bearings.123. INSPECTION AND REPAIR.Before inspection, clean all parts thoroughly in cleaning fluid andblow them dry with compressed air.a. Inspection. Inspection of the steering gear must cover the fol-lowing seven items:(1) STEERING TUBE. Replace the steering tube (fig. 2) if it isbent or otherwise damaged. Replace the bearing race if it is scored orpitted. If the bearing at the top of the steering tube is damaged, itmust be replaced.(2) ROLLER BEARINGS. Replace a roller bearing if any of therollers have flat spots, or if any of the rollers are missing.(3) STEERING TUBE SHAFT AND BALL NUT. The indi-vidual parts of the steering shaft and ball nut must be inspected todetermine the condition of the assembly.(a)STEERING TUBE SHAFT.Replace the entire steering shaft andball nut assembly if the worm on the shaft is pitted or otherwisedamaged.§ 123. a. (3)(a)3730-47J104Fig. 2—Steering Tube Shaft, DisassembledCOVER AND TUBE ASSEMBLY—3509SEAL—3570SPRING—3520BEARING—3517SPRING SEAL—3518STEERING SHAFT—3524BALL RETAINERSBALLS—353110-SCLAMP—34905-SBEARING CUP—3552ROLLER BEARING—3571BEARING CUP—3552 NUT—3539ROLLER BEARING—3571HOUSING3548RM-605

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?