Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 7 - Steering Gear

Disassembly page 103

Ford 8N, 9N, 2N Service Manual, page 103Fig. 1—Steering Gear AssemblyRemove the four cap screws that secure the sector shaft bearinghousing to the steering gear housing, and turn the sector shaft bear-ing housing and its metal gasket counterclockwise (as viewed fromthe left side of the tractor) to the next set of notching holes. Replaceand tighten the four cap screws.Check the effect of the adjustment by measuring the force requiredto turn the steering wheel through the straight ahead position, withthe pitman arms parallel. This measurement is taken with a springscale as described above. Two to three pounds should be required tomaintain the steering wheel in motion through the straight aheadposition.It is usually necessary to adjust the right sector if the left has beenmoved. Proceed as instructed for the left sector, except that the rightsector shaft bearing housing must be turned in a clockwise direction,as viewed from the right side of the tractor, to remove excessive back-lash. 21/2to 6 pounds should be required to maintain the steering gearin motion through the straight ahead position after both right andleft sectors have been adjusted.122. DISASSEMBLY.To disassemble the steering gear, remove the nut that secures eachpitman arm to the sector shafts. Remove each pitman arm with apuller. Remove the four cap screws that secure each sector shafthousing to the steering gear housing. Lift each sector shaft housing,thrust washer, gasket, and sector shaft from the steering gear hous-3730-47J§122.103STEERING GEAR TUBESTEERING GEAR HOUSINGOIL LEVEL PLUGSECTOR SHAFT HOUSINGPITMAN ARMWASHERRM-598

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?