Chapters
Chapter 6 - Hydraulic System
Hydraulic system adjustments page 100
of3/4inch between the edge of the lever and the top end of the slotin the quadrant as shown in fig. 29.(5) Make sure that the control arm moves freely and is held in ahorizontal position by its own weight as shown in fig. 29. Loosenthe position control lock nut, and adjust the length of the positioncontrol spring by turning the position control spring adjustmentbolt (fig. 30). Adjust the position control spring length until theposition control pin contacts the cam, and the position control springadjustment bolt contacts the control arm, as shown in fig. 29. Itwill probably be necessary to hold the position control pin in contactwith the cam. The position control spring length should be 129/32inches plus or minus1/16inch after the adjustment has been made(fig. 30). Tighten the position control spring lock nut after complet-ing the adjustment.After the above adjustments have been made, check the positionof the hydraulic touch control lever and lift arms to be sure theywere not moved while making the adjustments.(6) Install the hydraulic unit on the tractor, making sure thatthe end of the control arm enters the opening in the valve controllever and that the control arm is not bent or damaged in any wayduring this operation. Do not install the inspection plate.(7) Place the position control lever in the forward position,support the lower links near the raised position, and place thehydraulic touch control lever at the top of the quadrant. Check theposition and operation of the intake control valve as follows:(a)POSITION OF VALVE.The valve should be completely openwhen the hydraulic touch control lever is at the top of the quadrant.The valve is open when, by inserting the hand in the inspectionopening, it is impossible to press the end of the control valve armtoward the pump face any farther.(b)OPERATION OF VALVE.Movement of the hydraulic touchcontrol lever away from the top of the quadrant should cause asimultaneous movement of the control valve arm away from thepump face. Movement of the control valve arm should begin at thestart of movement of the hydraulic touch control lever.There is only one position in which the quadrant support platecan be located where both of the above conditions will be met. Tofind this position, slightly loosen the four cap screws that supportthe quadrant. Hold the hydraulic touch control lever at the top ofthe quadrant and gently tap the quadrant support plate forward orbackward until both of the above requirements are fulfilled.(8) Tighten the four quadrant support cap screws securely andinstall the inspection plate on the center housing.ยง 143. b. (8)3730-47J100Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
