Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 7 - Steering Gear

Assembly page 109

Ford 8N, 9N, 2N Service Manual, page 109a pull of 2 to 3 pounds is required to turn the steering wheel throughthe straight ahead position (fig. 7).Place the right sector shaft and thrust washer in the sector shaftbearing housing, and position the metal gasket on the housing. Theright sector must be engaged with its center tooth meshed in the thirdtooth space on the left sector gear, counting from the solid section ofthe gear, located on the bottom, as shown in fig. 8. The tooth onthe right sector can be identified by a dot or mark on the end of thetooth.The tooth space on the left sector also can be identified by a dot ormark. The bearing is eccentric in the sector shaft bearing housing andshould be installed with the notch located at the bottom. Rotate thehousing clockwise (as viewed from the right side of the tractor) toreduce backlash.The adjustment between the right and left sector should be suchthat the force required to turn the steering wheel through the straightahead position is 3 to 6 pounds.The steering gear assembly should be filled with S.A.E. 90 oil. Thisoil may be pumped into the right side of the steering gear housingthrough the pipe plug hole.3730-47J§124.b.109Fig. 8—Timing Sector Shaft and Ball NutLEFT SECTOR RIGHT SECTORBALL CIRCUITSSTEERING SHAFTBALL NUTRM-643

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?