Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 7 - Steering Gear

Inspection and repair page 105

Ford 8N, 9N, 2N Service Manual, page 105(b)BALL NUT.Replace the entire steering shaft and ball nutassembly if the teeth are worn or if the ball race is pitted.(c)BALL BEARINGS.Replace the entire steering shaft and ballnut assembly if any balls are worn, chipped, or pitted. Be sure thatthere are 60 balls within the assembly. Since these balls are held to avery close tolerance, it is not advisable to replace them individually.(d)BALL RETAINERS.Replace the retainers if they are bent,damaged, or will not permit free passage of the balls.(4) STEERING GEAR HOUSING. Replace the steering gearhousing (fig. 3) if it is cracked or otherwise damaged. Replace thelower steering shaft bearing race if it is scored or pitted.(5) PITMAN ARM. Replace a pitman arm (fig. 3) that has beendamaged in any way.(6) SECTOR SHAFT HOUSING. Replace the housing if it isdamaged. Replace the sector shaft bushings if they are damaged orworn.(7) SECTOR SHAFT. Replace a sector shaft (fig. 3) if the teethor bearing surface are excessively worn.b. Repair. To replace a bearing race, remove it from the housingor steering tube shaft with a puller. To install a bearing race, pressit in place, making sure that it is seated firmly against the shoulderin the housing or steering tube.To replace a sector shaft bushing, remove the seal and seal washer,then press the bushing from the housing, being careful not todamage the bore. Press the new inner bushing into the housing until3730-47J§123.b.105Fig. 3—Sector Shafts, DisassembledSTEERING SHAFT—3524COVER AND TUBE ASSEMBLY—3509SECTOR SHAFT HOUSINGAND BUSHING —3584SECTOR SHAFTPITMAN ARM—3590WASHER-3579HOUSING-3548SECTOR SHAFTGASKET—3581COVER AND BUSHING ASSEMBLY—3584COVER AND TUBE ASSEMBLY—3509GASKET—3581WASHER—3579PITMAN ARM—3590 RM-610

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?