Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 5 - Rear Axle

Assembly page 87

Ford 8N, 9N, 2N Service Manual, page 87Fig. 43—Installing Axle Shaft Bearinge. Axle Shaft Bearing Retainer. Replace the bearing race(subpar. (1) below) if it is scored or pitted. Discard all used gasketsand oil seals.(1) REAR AXLE OIL SEAL AND BEARING RACE RE-PLACEMENT. To remove the rear axle oil seal or bearing race,drive it out of the retainer with a brass drift. To install, drive it intothe retainer with a driver that applies pressure evenly on the raceor oil seal.153. ASSEMBLY.Place the drive pinion sleeve in a vise equipped with brass jaws.Be sure that the bearings are thoroughly clean and that they havenot been lubricated. The lubricant should not be applied to thebearings until after the bearing tension has been adjusted. Slide thedrive pinion and bearing in the sleeve. Place the other bearing andthe thrust washer on the pinion. Install the bearing adjusting nutand tighten the nut, using two 21/8-inch thin, open end wrenches,until a torque of 12 to 16 pounds-inches is required to turn thepinion. After the correct adjustment is obtained, hold the adjustingnut with the wrench, and install the lock washer and lock nut.Tighten the lock nut while holding the adjusting nut stationary.Recheck the torque. Bend the tabs of the lock washer over both thelock nut and the adjusting nut.Be sure that the drive pinion surface on the center housing has nonicks or high spots. Place the drive pinion assembly in position on thecenter housing. Line up the dowel pin in the sleeve of the pinion withthe hole in the housing. Install the pinion assembly by applyingpressure to the drive pinion shaft (fig. 38). Install the six cap screws3730-47J§153.87RM-650PullerAXLE SHAFTBEARING WEDGEBEARING

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?