Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 5 - Rear Axle

Assembly page 88

Ford 8N, 9N, 2N Service Manual, page 88that secure the pinion to the housing. Place the thrust washer anddifferential side gear in the drive gear assembly.Install the four differential spider pinion gears and thrust washerson the differential spider and place the spider, including the gears,in position on the drive gear assembly. Install the thrust washer anddifferential side gear in the differential gear case. Line up the match-ing numbers on the drive gear assembly and differential gear case sothat the numbers are directly opposite each other. Place the twoassemblies together. Install the eight bolts that secure the twoassemblies together and tighten them evenly. Lock the eight boltswith locking wire.Be sure that the differential side bearings are thoroughly clean,and apply a thin coating of grease on the bearings. Place a newgasket on the right-hand side of the center housing. Position theright-hand axle housing on the center housing. Install and tightenthe nuts. Position the differential assembly in the center housing withthe flat side of the drive gear facing the left-hand axle housing. Placea new gasket on the center housing. Position the axle housing on thecenter housing. Install and tighten the nuts.Install the axle shafts in the housings. Install the gaskets and theoil seal retainers on the bearing retainers. Secure the brake shoebrackets to the bearing retainers with two cap screws in eachbracket. Coat each axle housing flange with a light film of grease.Position the gaskets on the axle housings.Remove several of the shims of the shim pack previously used onthe bearing retainer, and place the remainder of the pack betweenthe brake plate and the bearing retainer. Hold the brake cross shaftin position, and install the brake plate and bearing retainer assemblyon the axle housing. Rotation of one axle shaft should now causethe other shaft to rotate in the same direction. If it does not, moreshims must be removed.Increase the shim pack thickness in steps of approximately 0.005inch. It may be necessary to exchange thick shims for thin ones, orvice versa, to produce the required addition. The shim thicknessmust be increased until the rotation of one shaft causes the otherto rotate in the opposite direction. By following this procedure, theamount of end play in the axles will be held to the desired limits(0.002 to 0.004 inch).Install the hubs, seals, flat washers, nuts, and lock rings.ยง 153.3730-47J88

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?