Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 5 - Rear Axle

Inspection and repair page 81

Ford 8N, 9N, 2N Service Manual, page 81Fig. 35—Differential Assembly, DisassembledRemove the six cap screws that secure the drive pinion sleeve tothe center housing. Install the puller, as shown in fig. 36, and removethe pinion assembly.Place the pinion assembly in a vise equipped with brass jaws. Bendthe ears of the lock washer off the pinion bearing lock nut. Usingtwo thin 21/8inch open-end wrenches, remove the pinion sleeve,thrust washer, and roller bearing from the pinion (fig. 42).152. INSPECTION AND REPAIR.Clean all parts thoroughly in cleaning fluid, and blow them dry.Discard all used gaskets and oil seals.a. Axle Housing. Replace the axle housing and the center housingif they are cracked or bent. Replace the differential bearing cups atthe inner end of the axle housings if they are pitted, corroded ordiscolored due to overheating (subpar. (1) below). Replace thethrust block on the left-hand axle housing if it shows wear. Replacethe drive pinion pilot bearing in the center housing if the rollers haveany flat spots, are discolored due to overheating, are pitted, or if theybind when rotated by hand (subpar. (3) below).(1) DIFFERENTIAL BEARING CUP REPLACEMENT. Toremove the differential bearing cups from either the right- or left-hand axle housing, use a puller that hooks behind the bearing cup.To install the bearing cup in either the right- or left-hand axle hous-ing, use a replacer that pulls the bearing cup in place evenly, anddraw the cup in flush with the shoulder in the axle housing.3730-47J§ 152. a. (1)81DIFFERENTIAL GEARCASE ASSEMBLY—4205DIFFERENTIALBEARING—4221RING GEAR4210THRUST WASHERS—4230DIFFERENTIAL SPIDER GEARS—4215DIFFERENTIAL SPIDER—4211DIFFERENTIAL BEARING CUP—4222RM-616BOLTS—4216DIFFERENTIAL BEARING—4221DIFFERENTIAL BEARING CUP—4222THRUST WASHER—4228DIFFERENTIAL SIDE GEAR—4236DIFFERENTIAL SPIDER GEARS-4215THRUST WASHERS—4230DIFFERENTIAL SIDE GEAR—4236THRUST WASHER—4228DIFFERENTIAL GEARCASE ASSEMBLY—4206BOLTS4216

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?