Chapters
Chapter 5 - Rear Axle
Inspection and repair page 86
Fig. 41—Drive Pinion Assembly, Disassembledd. Axle Shaft. Replace the axle shaft (fig. 36) if the splines orthreads are damaged. Replace the axle shaft bearing (subpar. (1)below) if the rollers have flat spots or if any rollers are missing.(1) AXLE SHAFT BEARING REPLACEMENT. Remove theaxle shaft bearing with a puller that applies pressure on the innerrace (fig. 42). To install the bearing, press it on the shaft, makingsure all pressure is applied to the inner race (fig. 43).Fig. 42—Removing Axle Shaft Bearing§ 152. d. (1)3730-47J86BEARING WEDGEAXLE SHAFTBEARINGPullerRM-621CAP SCREWS (6)-20690-SWASHER—34810-SBEARING NUT LOCK WASHER—4636MBEARING CUP-4616MPINION SLEEVE—4614MPILOT BEARING—4626MDRIVE PINION-4610MBEARING—4621BEARING CUP-4616MDOWEL PIN—72811-SBEARING-4621WASHER—4667BEARING NUTS-356139-SRM-670Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
