Chapters
Chapter 5 - Rear Axle
Inspection and repair page 82
Fig. 36—Removing Drive Pinion Assembly(2) THRUST BLOCK REPLACEMENT. To remove the thrustblock, remove the two cap screws which secure the thrust block tothe axle housing, and remove the block. To install, position the blockin place on the housing, and install the two lock washers and capscrews.(3) DRIVE PINION PILOT BEARING REPLACEMENT.Remove the pilot bearing, using a puller that applies pressure on thebearing outer race (fig. 37). To install a new pilot bearing, place thepilot bearing in position in the housing, and install the bearing,using a tool that applies pressure on the bearing outer race.b. Differential Assembly. The drive gear assembly (includingthe differential gear case) and the drive pinion are furnished only inmatched sets, and, if either is damaged, both must be replaced.Replace the drive gear assembly if it has chipped or missing teeth,or loose or missing drive gear rivets. Rotate the bearings on the drivegear assembly and the differential gear case by hand. If eitherbearing binds, has excessively loose races, is pitted, or is discoloreddue to overheating, replace the bearings (subpar. (1) below).Replace the differential spider if the diameter is excessively wornat the differential spider gear bearing surfaces. Replace the differential§ 152. b.3730-47J82RM-618CENTERHOUSINGDRIVE PINIONDRIVE PINIONB—INSTALLING DRIVE PINIONCENTER HOUSINGA—REMOVING DRIVE PINIONFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
