Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 4 - Belt Pulley

Assembly page 78

Ford 8N, 9N, 2N Service Manual, page 78173. ASSEMBLY.Install new oil seals in the drive shaft and pulley sides of thehousing (fig. 51). Make sure the pulley shaft outer bearing innerrace is in place before this seal is installed. Install the drive gear andbearing assembly in the housing.Position the pulley shaft assembly part way in the housing, andinstall the inner bearing, driven gear, flat washer, and nut on theshaft. Tighten the nut, then tap the pulley shaft into the housingwith a rawhide hammer. Repeat this procedure until the pulley shaftrequires a torque of 5 to 12 pounds-inches to turn it freely. Install acotter pin in the nut and shaft. Install a new gasket and position thecover on the housing. Install and tighten the four lock washers andcap screws. Secure the pulley to the pulley shaft with four capscrews and lock washers. Insert the power take-off shaft in thesplines. Install a torque indicator on the shaft, and turn the shaftwith the indicator. The reading should be 15 to 34 pounds-inches.Gaskets are supplied in thicknesses ranging from 0.012 to 0.023 inch.Install a thicker gasket to decrease the torque reading or a thinnergasket to increase the reading.ยง 173.3730-47J78

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?