Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 6 - Hydraulic System

Hydraulic system adjustments page 98

Ford 8N, 9N, 2N Service Manual, page 98POSITION INDICATION MARKSFig. 29—Hydraulic Unit in Position for AdjustmentsOM-4 16(2) ADJUSTMENT OF FORCE REQUIRED TO MOVEHYDRAULIC TOUCH CONTROL LEVER. This is accomplishedby tightening or loosening the nut on the end of the hydraulic touchcontrol lever shaft (fig. 17). Tightening the nut increases the forcerequired to move the lever. It should be set so that it requires a pullof 4 to 5 pounds on the knob to move the lever.b. Internal Adjustments. The internal adjustments have beencarefully made at the factory. However, it may be necessary toreadjust the hydraulic unit after an overhaul. These internal adjust-ments must be made before the unit is installed on the tractor.The first step in making the internal adjustments is to check thetwo external adjustments as outlined above, and adjust if necessary.(1) Support the unit in a vise in a vertical position with the controlspring down as shown in fig. 29.The lift arms must be supported in the fully raised position asindicated by the marks on the lift arms and housing (fig. 29).§ 143 b. (1)3730-47J98CONSTANT DRAFT SPRING ADJUSTMENT NUTCASTLE NUTSELF LOCKINGNUTCONTROL ARMPOSITION CONTROLSPRING ADJUSTMENT BOLTPOSITIONCONTROL SPRINGPOSITION CONTROLSPRING LOCK NUTCAM3/4INCHPOSITION CONTROL PIN

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?