Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 5 - Rear Axle

Inspection and repair page 85

Ford 8N, 9N, 2N Service Manual, page 85Fig. 40—Removing Drive Pinion Bearing Outer Race(1) DRIVE PINION BEARING CUP REPLACEMENT. Placethe drive pinion sleeve in a vise and, using a puller that hooks behindthe bearing cup, pull the bearing cup (fig. 40). Repeat this operationto remove the other cup. To install new bearing cups, place thepinion sleeve in a vise. Place the cups in position on the pinionsleeve and, using a replacer that contacts the bearing cups evenly,draw the cups in the sleeve until they are seated flush with theshoulder in the sleeve.(2) DRIVE PINION BEARING REPLACEMENT. Removethe bearing from the pinion, using a puller that applies pressure tothe inner race. Install a new bearing, using a puller that applies pres-sure to the inner race of the bearing.(3) DRIVE PINION PILOT BEARING INNER RACE RE-PLACEMENT. Remove the lock ring, using a sharp punch. Placethe drive pinion so that the race rests on a solid base and, with atwo-pound hammer, strike repeated blows along the race surface.This will cause the race to expand slightly. Drive a sharp chiselbetween the rear edge of the race and the pinion shoulder to startthe race. Drive the race off the pinion, using a heavy punch. To installa new race, place it on the pinion with the chamfered side facing thepinion. Press the race on the pinion until it is against the shoulder ofthe pinion. Install the lock ring.3730-47J§152.C(3)85PullerDRIVE PINION BEARING SLEEVEBEARING CUPRM-652

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?