Chapters
Chapter 5 - Rear Axle
Inspection and repair page 83
Fig. 37—Removing Drive Pinion Pilot Bearingspider gears if they have chipped, pitted, or missing teeth, or if theinside diameter is excessively worn. Replace the differential sidegears if they have broken, chipped, pitted, or excessively worn teethor splines.Insert a new axle shaft in the differential side gear. If the backlashis excessive, replace the differential side gear. Replace the differentialspider gear thrust washer if excessively worn.(1) DIFFERENTIAL BEARING REPLACEMENT. Removethe bearing from either the drive gear assembly or the differentialcase, using a puller that applies pressure to the inner race (fig. 39).To install a new bearing on the drive gear assembly or differentialcase, place either part in a press and, with a driver that appliespressure to the inner race evenly, press the bearing on the case untilit is firmly seated on the shoulder of the case.c. Drive Pinion Assembly. The drive gear assembly and thepinion gear are furnished only in matched sets, and if either isdamaged, both must be replaced. Replace the drive pinion sleeve ifit is cracked. Replace the drive pinion bearing cups in the sleeve ifthey are cracked, pitted, corroded, or discolored due to overheating(subpar. (1) below). Replace the drive pinion if the gear has chipped,pitted, or missing teeth, or if the shaft has damaged threads orsplines. Replace the pilot bearing inner race at the end of the drive3730-47J§152.C.83RM-644PullerCENTER HOUSINGFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
