Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 3 - Power Take-Off

Assembly page 74

Ford 8N, 9N, 2N Service Manual, page 74POWER TAKE OFF SHAFTRM-655Fig. 49—Checking Bearing Preload163. ASSEMBLY.To assemble the power take-off adapter, position the sleeve on theshaft, and secure it to the shaft with a rivet (fig. 47). Install thebearing and shaft assembly in the housing with the sleeve end of theshaft towards the rear of the housing (fig. 47). Press the oil seal(fig. 47) in the bearing retainer. Install the bearing retainer, shims,and guard on the housing. Adjust the preload to 5 to 12 pounds-inches by increasing the shim pack to reduce the preload or bydecreasing the shim pack- to increase the preload.To assemble the power take-off shaft assembly, press the oil seal(fig. 48) in the cover. Press the cover assembly onto the shaft andbearing. Install the rear snap ring in the cover. Install the cover cap.§ 163.3 730-4 7J74Torque Wrench

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?