Chapters
Chapter 4 - Belt Pulley
Inspection and repair page 76
76Fig. 51—Belt Pulley, Disassembled172. INSPECTION AND REPAIR.Clean all parts thoroughly in cleaning fluid. Discard all usedgaskets and oil seals. Inspection must cover the housing, gears,shaft, bearings, and pulley.a. Housing. Replace the housing (fig. 51) if it is cracked, if thegasket surface is damaged, or if the threads are stripped. Replace abearing race if it is pitted, corroded, or cracked. To remove a bearingrace, drive it out of the housing with a brass drift. To install the race,drive it into the housing with a driver that will apply pressureevenly on all sides of the race.b. Drive and Driven Gears (Matched). Replace both gears ifeither gear has broken, chipped, or worn teeth, if the gears areexcessively noisy when operating, or if the oil seal surface on thedrive gear is damaged.c. Pulley Shaft. Replace the pulley shaft (fig. 51) if the splinesor oil seal surfaces are damaged or if the threads are stripped.d. Bearings. Replace a bearing (fig. 51) that is pitted, corroded,or if any of the rollers are missing. Remove the bearings with a pulleras shown in fig. 52.§ 172. d.3730-47JGASKET—747BEARING CUP—753BEARING CONE—743BEARING CUP—744RM-609SEAL—749COVER—741BEARING CONE—752GEAR—737NUT—33860-SWASHER—371505-S7GEAR-745HOUSING-762BEARING CONE-743BEARING CUP-744BEARING CONE—743SEAL—750PULLEY—740PULLEY SHAFT—746Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
