Chapters
Chapter 3 - Power Take-Off
Inspection and repair page 73
Fig. 47—Power Take-off Adapter, Disassembled(2) SHAFT. Replace the shaft (fig. 47) if it is broken or if thesplines are worn or damaged.(3) SLEEVE. Replace the sleeve if the splines are worn or dam-aged.(4) BEARING. Replace the bearing (fig. 47) if any of the rollersare missing, if they have flat spots, or if the surfaces are pitted orcorroded. Separate the bearings with a bearing wedge and removethem with a puller as shown in figs. 45 and 46.(5) BEARING RACE. Replace a bearing race that is scored,worn or pitted.(6) HOUSING. Replace the housing if it is cracked or if thethreads are stripped.b. Power Take-off Shaft. Replace the shaft and bearing as-sembly (fig. 48) if the splines are damaged, if the bearing is scored,or corroded, if the bearing race is loose, or if the oil and dust sealsurfaces are damaged. Always replace the oil seal if it has beenremoved.Fig. 48—Power Take-off Shaft, Disassembled§ 162. b.733730-47JGUARD-230020SEAL-230017BOLT-20470-S7-8LOCK WASHER—34808-S7-8COVER-230019SHAFT-230014SHIMS—230018LUBRICATOR FITTING—353027-A3-S7-8BEARING CUP—230012BEARING CONE—230016RIVET-60577-S7-8SLEEVE—230015HOUSING-230011RM-645RM-648CAP—726OIL SEAL—703COVER—733SNAP RING—754GASKET—4129SLEEVE—735BEARING—715SLEEVE—756SHAFT—725SNAP RING—754Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
