Chapters
Chapter 3 - Power Take-Off
Inspection and repair page 72
Fig. 45—Separating Power Take-off Adapter Shaft Bearingsb. Power Take-off Shaft. Remove the snap ring from the rearof the bearing. Press the shaft and bearing assembly from the powertake-off cover. Press the dust and oil seal out of the power take-offcover (fig. 48).162. INSPECTION AND REPAIR.Clean all parts thoroughly in cleaning fluid. Discard all usedgaskets and oil seals.a. Power Take-off Adapter. The adapter assembly comprisesthe guard, shaft, sleeve, bearing, bearing race, and housing.(1) GUARD. Replace the guard (fig. 47) if it is distorted or bentbeyond repair.72Fig. 46—Removing Power Take-off Adapter Shaft Bearings§ 162. a. (1)3730-47JBearing WedgePOWER TAKE-OFF ADAPTOR SHAFTBEARINGBEARINGRM-657PullerSHAFTBEARINGBearing WedgeRM-646Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
