Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 2 - Transmission

Assembly page 68

Ford 8N, 9N, 2N Service Manual, page 68Fig. 16—Shift Rails and Shift Forksone 0.005 inch shim will increase the torque approximately 10 pounds-inches. Adding a 0.005 inch shim will decrease the torque a likeamount.Install the two lower shift rails and shift forks making sure that thedeep square cornered slots face inward on both rails. Install the inter-lock ball spring and nut on each side of the housing. Install the mainshaft assembly being careful not to damage the gear teeth. Install therear main shaft bearing retainer assembly, using the metal shim packpreviously removed and identified. Install the main drive gear bear-ing retainer assembly and gasket. Position all shift rails and forks inthe neutral position and measure the torque required to turn the mainshaft. Several turns should be completed so that the bearings will beproperly seated. After the shift is turning uniformly, the torqueshould be from 20 to 35 pounds-inches. Add or remove shims as3730-47J§133.f.68FIRST AND THIRD GEAR SHIFT RAIL—7240THIRD AND FIRST GEAR SHIFT FORK—7230NUT-33911-SBOLT —7245REVERSE GEAR SHIFT RAIL—7242NUT-33911-SBOLT —7245REVERSE GEAR SHIFT PLATE-7216SECOND AND FOURTH GEAR SHIFT PLATE—7225SECOND AND REVERSE SHIFT FORK-7231BOLT7245NUT—33911-SSECOND AND FOURTH SHIFT RAIL-7241SECOND AND FOURTH GEAR SHIFT FORK-7236RM-615

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?