Chapters
Chapter 2 - Transmission
Assembly page 66
132. INSPECTION AND REPAIR.Inspection of the transmission must cover the following 9 items.a. Gears. Replace all gears which have broken or chipped teethor broken splines. Replace gears that rotate on a shaft and the insidediameter is excessively worn.b. Shafts. Replace a shaft that has broken or damaged splines orteeth. Replace a shaft if the bearing surface is scored or excessivelyworn.c. Bearings. Replace a bearing if it is scored or pitted or if anyrollers are missing.d. Bearing Cups. Replace any bearing cups that are scored orpitted.e. Thrust Washers. Replace cracked or broken thrust washers.f. Bearing Retainers. Replace cracked or damaged bearingretainers.g. Shift Forks. Replace damaged or broken shift forks or oneon which the threads are stripped.h. Shift Lever. Replace a damaged shift lever.i. Transmission Cover. Replace the transmission cover if it isdamaged or if the bracket rivets are loose.133. ASSEMBLY.Assembly of the transmission includes the assembly of the sub-assemblies and of the transmission itself. Make sure that all parts arein a serviceable condition before assembly.a. Main Shaft Assembly. To assemble the main shaft, press therear thrust washer and bearing on the shaft (fig. 11). Install the firstgear (60T) on the shaft with the coupling teeth facing toward thefront of the shaft. Install the coupling and sliding coupling on theshaft. Install the third gear (52T) on the shaft with the couplingteeth facing toward the coupling. Install the second (56T) and fourthgears (39T) on the shaft with the long end of the hubs touching eachother. Install the thrust washer and bearing on the shaft.b. Countershaft Assembly. Press the bearing on the rear of theshaft (fig. 12). Install the power take-off hub, flat washer, lockwasher, and cap screw. Install the countershaft second gear (18T)on the shaft, with the coupling teeth facing toward the front of theshaft. Press the countershaft coupling on the shaft with the sleeveend facing toward the front of the shaft. Install the sliding coupling.Install the fourth gear (36T) on the coupling sleeve with the couplingteeth on the gear facing towards the rear of the shaft. Press thecountershaft gear (55T) on the shaft with the long end of the hubfacing towards the rear of the shaft. Press the bearing on the shaft.3730-47Jยง133.b.66Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
