Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 2 - Transmission

Assembly page 67

Ford 8N, 9N, 2N Service Manual, page 67c. Reverse Idler Assembly. Install the reverse idler driven gear(23T) on the reverse idler gear (23T) and bushing assembly with thecoupling teeth facing the end of the hub (fig. 13). Install the thrustwasher and snap ring on the reverse idler gear and bushing assembly.Install the reverse gear coupling on the reverse idler driven gearsleeve with the coupling teeth facing the coupling teeth on thedriven gear.d. Power Take-off Shifter Assembly. Install the snap ring(fig. 14) in the bearing support. Install the clutch sleeve in the bearingsupport with the large end of the sleeve facing toward the bearingcup end of the bearing support. Install the bearing and snap ring inthe bearing support. Install the interlock spring and ball. Depress theinterlock ball, then push the shift rail into the bearing support untilthe threads on the rail are flush with the bearing support. Hold theshift rail stop in position in the bearing support and push the shiftrail into the shift rail stop. Install the nut and lock washer on theshift rail.e. Transmission Cover. If the shift lever has been removed, rein-stall it, securing with a lever pin. This pin should be installed with anarbor press or bench vise. Install the safety latch plate. Place spring(7227) in position as shown in fig. 15. Slide the gearshift lever throughthe spring and safety latch plate and turn it 90 degrees until the pinis properly seated in the slot in the bottom of the cover. Compress thespring and install the spring retainer (7228). Position a new gasketon the starter switch and install the switch in the cover. Place thestarter latch support over the threaded end of the switch and securewith a tabbed lockwasher and nut. Turn one of the tabs of the washeragainst the nut and secure the nut in place.f. Single Transmission. Before assembling the transmissionmake sure that all assemblies are clean and dry. Oil is not to beadded until after the bearing tension has been adjusted.Install the reverse idler assembly in the housing with the gears fac-ing toward the front. Hold a spacer washer between the coupling andthe housing and install the reverse idler shaft and lock ring. Positionthe countershaft assembly in the transmission housing with the largegear at the front of the housing. Install the countershaft front bearingretainer and gasket. Hold the countershaft in position and install thepower take-off shift assembly together with the shim pack which waspreviously removed and identified. Install the power take-off shaft inthe shift assembly. Measure the torque necessary to turn the powertake-off shaft. It should be from 15 to 30 pounds-inches. Add orremove shims as required to obtain this torque reading. Removingยง 133. f.3730-47J67

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?