Chapters
Chapter 2 - Transmission
Assembly page 69
required to obtain this torque reading. Removing one 0.005 inch shimwill increase the torque approximately 10 pounds-inches. Adding a0.005 inch shim will decrease the torque a like amount. Main shaftshims can be changed by supporting the rear main shaft bearingretainer over the power take-off shift shaft and sliding the shimsin or out.If it has been necessary to replace any of the transmission gears, acareful check should be made to make sure that all gears mesh prop-erly. Install the power take-off shaft in the power take-off shiftassembly. Engage the power take-off shaft with the transmission.Position the transmission in neutral and measure the torque requiredto turn the power take-off shaft. With the shaft turning uniformly,the torque should be from 30 to 60 pounds-inches. If more than 60pounds-inches of torque are required to turn the shaft, one or moreof the gears are binding at the teeth or on the hub shoulders. Deter-mine which gear is binding and replace it.Position the shift plates in the housing and install the shift platecap screws. Install the upper shift fork and shift rail, positioning thedeep square corner slot in the rail toward the opening in the shiftplates. Install the interlock ball and spring in the hole at the top ofthe housing. Using a new gasket, install the transmission cover.ยง 133. f.3730-47J69Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
