Chapters
Chapter 2 - Transmission
Disassembly page 65
Fig. 15—Transmission Cover, Disassembled(55T) and roller bearing off the countershaft. Lift the countershaftfourth gear (36T) and sliding coupling from the countershaft (fig. 12).Remove the countershaft coupling from the countershaft with a gearpuller or press. Lift the countershaft second gear (18T) from the shaft.(3) REVERSE IDLER GEAR ASSEMBLY. Remove the re-verse gear coupling from the reverse idler gear and bushing assembly(fig. 13). Remove the snap ring, thrust washer, and reverse idler gearand bushing assembly.(4) POWER TAKE-OFF SHIFTER ASSEMBLY. Remove thesnap ring from the rear of the bearing support (fig. 14). Lift the bear-ing and clutch sleeve from the bearing support. Remove the nut andlock washer from the shift rail, and remove the shift rail toward therear, being careful not to lose the interlock ball and spring. Lift outthe shift fork.(5) TRANSMISSION COVER. Slide the shift lever rubber bootup on the lever. Remove the starter switch. Compress the gearshiftlever spring, and remove the horseshoe-type spring retainer. Pull upon the gearshift lever and, by turning it 90°, lift it out of the assem-bly. Tilt the safety latch plate and remove it from the guide support(fig. 15). Drive the pin from the gearshift lever, and lift off the lever.§ 131. b. (5)3730-47J65TRANSMISSION COVER—7211SHIFT LEVER —7210SPRINGRETAINER—7228SPRING —7227NUT-33949-SSHIFTER LOCK—7229RM-606SAFETY LATCH —7257LOCKWASHER—351217-SSTARTER BUTTON-11500Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
