Chapters
Chapter 6 - Hydraulic System
Hydraulic pump page 96
(3) PISTON. Replace a piston (fig. 26) that is scored at anymachined surface.(4) CAM, CAM BLOCK, AND POWER TAKE-OFF BUSH-ING. Replace a cam, cam block, or power take-off bushing (fig. 26)if they are scored.(5) VALVE CHAMBER. Replace a valve chamber (fig. 24) if itis cracked or if the inlet valve or outlet valve seats are rough or pitted.(6) PUMP BASE. Replace the base (fig. 22) if it is cracked, ifthe gasket surface is nicked or damaged, or if any threads are stripped.c. Assembly. Lubricate all parts before assembly. Install theexhaust control valve (fig. 27) in the exhaust control valve bushing.Install the intake control valve, spring, washer, and spring retainer inthe bushing. Hold the intake control valve in the bushing, and installthe valve control lever (fig. 27). Connect the exhaust control valve tothe control lever with a clevis pin and cotter pin. Secure the controllever to the cover with a cotter pin. Install the safety valve assembly(fig. 24) on the pump base. Install the valve guide socket, valveguide, inlet valve, inlet valve spring, outlet valve, outlet valve spring,and valve chamber plug as shown in fig. 27. Secure the valve assemblyin place with the top clamp and cap screw. This procedure applies toboth the left and right valve chambers. Install the cam block onthe cam as shown in fig. 26. Install a piston on each cam block, mak-ing sure that the narrow parts of the offset on each piston are togetherwhen the pistons are installed on the cam blocks. After the pistonsare assembled on the cam block, the pistons may be fitted to thecylinders in a valve chamber to be sure that the pistons have beenassembled correctly on the cam block. Install the power take-offbushing in the pump base. The shoulder on the power take-offbushing must be installed toward the pump piston assembly.Position the pistons, cam block, and cam assembly in the pump base,§ 142. c.3730-47J96Fig. 27—Valve Chamber,DisassembledVALVE CHAMBER606—R.H.VALVE CHAMBER607—LH.RM-601VALVE GUIDE SEATS—627CAP SCREW —21442-SCLAMP—609 OUTLET VALVES-628SPRING SEATS—636OUTLET VALVE SPRINGS—646VALVE GUIDES—626INLET VALVE SPRINGS—647PIPE PLUGS-353055-SINLET VALVES—629Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
