Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 2 - Transmission

Disassembly page 62

Ford 8N, 9N, 2N Service Manual, page 62Fig. 10—Transmission With Cover RemovedTo remove the main drive gear bearing retainer assembly, hold theshaft and retainer together, and remove the retainer and gear asa unit.Remove the main shaft bearing retainer assembly, being sure thatthe metal shim pack is carefully identified as a unit. This will facili-tate adjustment after assembly.Remove the main shaft gear cluster as a unit. This should beaccomplished slowly so as to avoid damaging the gear teeth.Remove the two lower shift rails by removing the interlock screwplug, spring, and ball from each side of the housing. Loosen the nutson the shift forks and turn out the screw until the shafts are freeto slide on the forks. Slide the shift rails out of the rear of the housing.Remove the power take-off shift assembly. Keep the metal shimpack carefully identified as a unit. This will facilitate adjustmentafter assembly.Remove the countershaft gear cluster as a unit. Be careful not todamage the gear teeth.Remove the reverse idler assembly. Tap the forward end of theshaft to remove it and the horseshoe-type retaining washer from the3730-47J§ 131. a.62SHIFT FORK LOCK SCREWFORKSHIFT PLATE CAP SCREWSHIFT RAILSHIFT FORKLOCK SCREWINTERLOCK SPRINGSHIFT RAILRM-642SHIFT FORK LOCK SCREWFORKSHIFT PLATES

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?