are now being stamped with a punch mark which will enable you to always

realign them in the same position.

3. FIELD CORRECTION:

In performing rear axle service operations on tractors built prior to the

above serial number, we advocate the following field procedure. Before

disassembling the rear axle and hub, punch a similar mark on both the hub

and rear axle, so that in the reassembly operation you will be able to

match the hub to the rear axle as it was before disassembly.

STEERING

Bulletin Subject: Locating Marks for Adjustment of Front Wheel Toe-in

on the 8N Tractor

1. PROBLEM:

Difficulty in centering the steering arm over the front axle locating mark.

2. PRODUCTION CORRECTION:

Beginning with tractor serial number 8N-181515, toe-in marks on the front

axle were moved from the axle half to a point on the spindle housing

directly below the slot in the steering arm, when the wheels are straight

forward.

3. FIELD CORRECTION:

Until such time as there is a reprint for the Ford Tractor Operator's

Manual (3729-49-C), it will be necessary for dealers to inform customers

of the new location of these toe-in marks. The procedure for adjusting

the turnbuckle on the drag links remains the same. However, be sure to

align the slot in the steering arm with the toe-in mark on the spindle

housing.

ELECTRICAL

Bulletin Subject: Installation of Generator 8N-10000-B on 2N and 9N Tractors

1. NEW PARTS REQUIRED:

A. 8N-10000-B Generator

B. 2N-100422 Kit (This kit contains all parts necessary to complete subject

installation).

122